snfere.blogg.se - Update cleanflight firmware on spf3

Here are the steps I take to do it successfully.ĮDIT: (2-15-2016) - I believe Cleanflight firmware stopped supporting flashing from Open Pilot. See the CLI section of the docs for details on how to backup and restore your configuration via the CLI.Updating betaflight with a CC3D can be stressful if you don't take the proper steps. Some firmware releases are not backwards compatible and default settings are restored when the FC detects an out of date configuration.

When upgrading be sure to backup / dump your existing settings. See the board specific flashing instructions.

When the progress bar becomes green and reads "Programming: SUCCESSFUL" you are done!.

Click on the "Flash Firmware" button and hold still (do not breathe, too).

Ensure the correct serial port is selected.

Connect the flight controller board to the PC.

If this is the first time Cleanflight is flashed to the board, tick the "Full Chip Erase" checkbox.

When upgrading review all release notes since your current firmware.

IMPORTANT: Read and understand the release notes that are displayed.

Click on the "Choose a Firmware / Board" dropdown menu, and select the latest stable version for your flight controller.

Make sure you have internet connectivity and click on the "Load Firmware " button.

Click on "Disconnect" if the configurator connected to the board automatically.

Connect the flight controller to the PC.

Make sure you have the Cleanflight Configurator installed, then: The configurator does not yet support all boards, so please check the documentation corresponding to your board before proceeding.

This is a generic procedure to flash a board using the configurator.